Extreme Networks Summit X430 Series Installation Notes page 7

WARNING!
Laser optic modules become very hot after prolonged use. Take care when removing a laser optic module
from the module or option card. If the laser optic module is too hot to touch, disengage the laser optic module and
allow it to cool before removing it completely.
WARNING!
When working with laser optic modules, always take the precautions listed below to avoid exposure to
hazardous radiation.
Never look at the transmit LED/laser through a magnifying device while the transmit LED is
●
powered on.
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are
●
powered on.
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
●
beam when optical connections are unplugged.
Never alter, modify, or change an optical device in any way other than suggested in this
●
document.
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP Regulatory
Compliance
Extreme Networks pluggable optical modules and direct-attach cables meet the following regulatory
requirements:
Class 1 or Class 1M Laser Product
●
EN60825-1:2007 2nd Ed. or later, European standard
●
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
●
Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low
●
Voltage Directives
UL and/or CSA registered component for North America
●
47 CFR Part 15, Class A when installed into Extreme products
●
Summit X430-8p Switch I/O Ports
The front panel of the Summit X430-8p switch includes:
Eight fixed autosensing 10/100/1000BASE-T ports (ports 1–8) that provide 8 Gbps of high-density
●
copper connectivity. In addition, all of these ports (ports 1-8) also support the POE protocol
IEEE802.af and POE+ protocol IEEE 802.at standard and can provide 15.4 Watts of power on a single
port up to a total power budget of 60 Watts.
Two unpopulated 1000BASE-X unpopulated SFP ports (ports 9–10) that provide 2 Gbps of fiber
●
connectivity.
Ethernet management port.
●
Serial console port implemented as an RJ-45 connector, used to connect a terminal and perform local
●
management.
Summit X430 Series Switches Installation Note
Fiber Optic Ports and Optical Safety
7