OLIGHT SR MINI INTIMI DATOR II User Manual

Thank you for purchasing Olight products! Please read this manual
carefully before use.
INSIDE THE BOX
Flashlight, holster, USB cable, user manual (this manual), and other optional
accessories( refer to the label marks outside of box for detail)
SUPPORTED BATTERIES
3 x 18650 rechargeable lithium batteries with protecting circuit board , the
batteries must have a protruding button on positive pole.
OPERATION INSTRUCTION
BATTERY INSTALLATION
Ÿ
Before use, install the batteries and notice that the battery positive towards
the flashlight head, then tightly screw the tail-cap as shown below.
TURN ON/OFF
Ÿ
Quick click the side switch to turn the flashlight on or off. The light will turn to
the last output mode before shutting off.
CHANGE BRIGHTNESS LEVELS
Ÿ
With the light on, press and hold the side switch, the output will cycle through
low, medium, and high brightness levels. Release the side switch when the
desired brightness level is achieved.
LOW MODE
Ÿ
With light off, press and hold the side switch for more than 1 second, the low
mode will be activated.
TURBO MODE
Ÿ
Double-click the side switch to activate turbo mode if the light is in non-
locking state.
STROBE MODE
Ÿ
When the light is in non-lock state, Triple-click side switch to activate strobe
mode. Click the side switch once to quit strobe mode, press and hold side
switch to turn on the setting of changing brightness level.
LOCK MODE
Ÿ
With the light off, press the side switch and hold for 1 second to activate low
mode, keep holding the switch for one more second, the light will shut off
automatically and lock the side switch. Under lock state, click and release the
switch, the red indicator will last for 2 seconds.
UNLOCK MODE
Ÿ
When the light is off, press and hold side switch for more than 2 seconds, the
switch is enable and activate low mode. User may twist the tail cap anti-
clockwise to turn off the light, tighten the tail cap clockwise to unlock the
light.
STATUS INDICATOR
Ÿ
There is a multi-purpose status indicator lamp at the upside of the USB
charging port to indicate the battery low voltage or charging state:
Battery low voltage indication: When the battery voltage is less than 3.25V,
the status indicator lamp will flicker in red; when the battery voltage is less
than 3.05V, the status indicator lamp will be a constant red.
Charging state indication: red means under charging; green means fully
charged.