Rear View (Terminal Panel) - NEC P506QL User Manual

Rear view (Terminal Panel)

I L
TEM ABEL
1.
SERVICE
2.
USB POWER (5V/2.0A)
3.
AUDIO OUT
4.
AUDIO IN
5.
COMPUTER IN
6.
HDMI 1 IN
7.
HDMI 2 IN
8.
Ethernet HDBaseT
9.
LAN
10. PC CONTROL
11.
3D-SYNC
12.
AC IN
13.
Security chain opening
Note:

To use this feature, you must plug in the connector before turn on/off the projector.

Do not use this jack for anything other than intended use.
Note:
As a safety precaution, disconnect all power to the projector and connecting devices before making connections.
D
ESCRIPTION
For service personnel only.
5V POWER supply Only..
Note: Support 5V/2.0A output as long as the projector Power On.
Connect an AUDIO cable for audio loop through.
Connect an AUDIO cable from the audio device.
Connect an RGB cable from a computer.
Connect the HDMI cable from an HDMI device.
Connect the HDMI cable from an HDMI device.
Connect a LAN cable from Ethernet.
Connect Cat5e/Cat6 cable from HDBaseT TX Box (VIDEO EXTENDER) for
HDBaseT signal received.
Connect a LAN cable from Ethernet.
Connects RS-232 serial port cable for remote control.
Connect 3D-sync in cable from a computer or an enabled device.
Connect the POWER cable.
Secures to permanent object with a Kensington Lock
system.
– 5 –
1 Getting Started
S
EE PAGE
46