NEC P506QL User Manual page 11

Laser Safety Caution
Obey the laws and regulations of your country in relation to the installation and management of the device.
For China
This product is classified as Class 3R of GB 7247.1-2012.
CLASS 3R LASER PRODUCT OF GB 7247.1-2012
LASER RADIATION - AVOID DIRECT EYE EXPOSURE.
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
For other regions
This product is classified as Class 1 of IEC 60825-1 Third edition 2014-05 and RG2 of IEC/EN 62471-5 First edition.
CLASS 1 LASER PRODUCT OF IEC 60825-1 THIRD EDITION
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
Laser energy exposure near aperture may cause burns.
USA only
Complies with 21 CFR 1040.10 and 1040.11 except for conformance as a Risk Group 2 LIP as defined in IEC/EN
62471-5:Ed. 1.0. For more information see Laser Notice No. 57, dated May 8, 2019.
Do not allow to look into the projector beam at any distance from the projector. An adult should supervise the
children to prevent exposure risks.
Check that there is no one looking at the lens, when using the remote control for starting the projector.
Do not look at the projected light using optical devices(binoculars, telescopes, magnifying glasses, reflectors,
etc).
[ WARNING: MOUNT ABOVE THE HEADS OF CHILDREN. ]
The use of a ceiling mount is recommended with this product to place it above the eyes of children.
Outline of laser emitted from the built-in light module:
Wave length: 450 460 nm
Maximum power: 170 W
Radiation pattern from the protective housing:
Wave length: 450 460 nm
Maximum laser radiation output: 32 mW
Pulse duration: 1.34 ms
Repetition frequency: 120 Hz
The laser module is equipped in this product. Use of controls or adjustments of procedures other than those specified
herein may result in hazardous radiation exposure.
Light Module
A light module containing multiple laser diodes is equipped in the product as the light source.
These laser diodes are sealed in the light module. No maintenance or service is required for the performance of the
light module.
End user is not allowed to replace the light module.
Contact qualified distributor for light module replacement and further information.
– x –
Important Information