Hyundai KONA 2020 Manual page 101

If you need to recalibrate the com-
pass:
1. Press and hold the Control Button
for more than 6 seconds. When
the compass memory is cleared, a
"C" will appear in the display.
2. Drive the vehicle in 2 complete cir-
cles at less than 8 km/h (5 mph).
Integrated HomeLink ® Wireless
Control System
The HomeLink ® Wireless Control
System can replace up to three
hand-held radio-frequency
transmitters with a single built-in
device. This innovative feature will
learn the radio frequency codes of
most current transmitters to operate
devices such as gate operators,
garage door openers, entry door
locks, security systems, even home
lighting. Both standard and rolling
code-equipped transmitters can be
programmed by following the out-
lined procedures.
Additional HomeLink ® information
can be found at: www.homelink.com,
www.youtube.com/HomeLinkGentex
or by calling 1-800-355-3515.
Retain the original transmitter of the
RF device you are programming for
use in other vehicles as well as for
future HomeLink ® programming. It is
also suggested that upon the sale of
the vehicle, the
®
HomeLink buttons be erased for
security purposes.
WARNING
Before
HomeLink ® to a garage door
opener or gate operator, make
(RF)
sure people and objects are out
of the way of the device to pre-
vent potential harm or damage.
Do not use the HomeLink
any garage door opener that
lacks the safety stop and
reverse features required by
federal safety standards (this
includes any garage door open-
er model manufactured before
April 1, 1982). A garage door
that cannot detect an object -
signaling the door to stop and
reverse - does not meet current
federal safety standards.
Using a garage door opener
without these features increas-
es the risk of serious injury or
death.
programmed
Programming HomeLink
Please note the following:
• When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
programming
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink
training and accurate transmission
of the radio-frequency signal.
®
with
• Some vehicles may require the
ignition switch to be placed in the
ACC (or "Accessories") position for
programming and/or operation of
HomeLink
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps
HomeLink
www.youtube.com/HomeLinkGentex
or by calling 1-800-355-3515.
®
® for quicker
® .
listed below, contact
® at: www.homelink.com,
3-27
3