Sum Of Cathetuses; Timer; Memory; Bluetooth - CONDTROL XP3 PRO User Manual

LASER DISTANCE METER
EN
Calculation of distance by 3 additional measurements (Sum of cathetuses)
Press 4 times Symbol
Press First measurement (hypotenuse 1).
Press Second measurement (cathetus).
Press Third measurement (hypotenuse 2).
– hypotenuse 1 (measured)
– cathetus (measured)
– hypotenuse 2 (measured)
– cathetus (calculated)

Timer

Press
Activate timer. Default value is 5 seconds.
Press or Adjust the timer response time.
Press Start timer.

Memory

Enter memory. A number of saved measuring results is
Press
reflected on symbol
Press or Flip through saved measuring results.
18
XP3 PRO CONDTROL
User manual
appears on the display.
on the display.
LASER DISTANCE METER
EN

Bluetooth

Activate Bluetooth function.
Press
Symbol
Bluetooth in your phone, tablet PC or laptop. For
further operation please use application Smart
Measure CONDTROL.

MESSAGE CODES

While operation, the following codes/symbols may appear on the display:
Message Cause
ERR Out of measuring range
ERR 1 Laser signal is too weak
ERR 2 Laser signal is too strong
ERR 3 Low battery voltage.
The ambient temperature is
ERR 4
out of the working range.
Measuring error in
ERR 5
Pythagoras function.
ERR 6 Failure of tilt sensor.
XP3 PRO CONDTROL
User manual
appears on the display. Switch on
Solution
Use the device within the range.
Use the reflecting plate.
Use the reflecting plate.
Сharge or replace the batteries.
Use the device in the specified
temperature.
Measure again and ensure
that hypotenuse is bigger than
cathetus.
Please contact service center.
19