Advertisement
(e.g. obstruction of air intake and outlet grilles, motor turning
slowly or not at all). To reset, unplug the appliance from the
mains socket for a few minutes, remove the cause of overhe-
ating then plug in again. If the appliance doesn't work please
contact the De'Longhi Customer Service.
Use in compliance with intended use
Use this heater only as described in this manual. All other use
is considered improper. This appliance is not suitable for
commercial use. The manufacturer is not liable for damage
deriving from improper use of the appliance. This is a
household appliance only. It is not intended to be used in:
•
staff kitchen areas in shops, offices and other working
environments;
•
farm houses;
•
by clients in hotels, motels and other residential type
environments;
•
bed and breakfast type environments.
Use in this manner will invalidate the manufacturers
warranty.
Disposing of the appliance
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
Fundamental recommendations regarding safety
Dear Customer – The plug on this appliance will get 'warm'
during use, this is perfectly normal. This product is A HIGH
POWER HEATING APPLIANCE designed to our usual high
standards but please make sure your wall sockets are in good
condition and the plug is inserted correctly to avoid any
accidental overheating. We suggest that you check the plug
AND THE SOCKET regularly if the heater is in prolonged use, if
you are in any doubt please consult an electrician.
DESCRIPTION
(pag. 3)
A
Thermostat
B
Function selector
C
Indicator light
USE
Electrical connection
-
Before plugging into the mains, make sure the voltage of
your mains supply corresponds to the value V indicated
on the appliance and that the socket and power line are
appropriate for the load required.
-
THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EC
ON ELECTROMAGNETIC COMPATIBILITY.
Location
If the appliance is located in a room with bath or shower, re-
spect the "safety distances" shown in fig. 1 and always install
away from taps, basins, showers, etc.
Functioning and use
Make sure the appliance is off before plugging into the mains.
1. Plug the appliance into the mains. The light comes on.
If your appliance has a timer, see the section "Models
with 24 hour timer". However, to operate the appliance
without programming, move all the teeth of the timer to
the outside.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the
position.
4. Low power operation: turn the function selector to po-
sition 1 (in models with two fan speeds, the fan operates
at minimum).
5. Medium power operation: turn the function selector
to position 2 (in models with two fan speeds, the fan
operates at maximum).
6. High power operation: turn the function selector to
position 3 (the fan operates at maximum).
7. Switching off: turn the function selector to the "0" posi-
tion.
Setting the thermostat
Position the thermostat on maximum. When the room has
reached the required temperature, turn the thermostat dial
slowly anticlockwise until you hear a click and the fan goes
off. The thermostat will then keep room temperature at the
selected level automatically.
Frost prevention mode
With the function selector in position 3 and the thermostat
dial in position
, the appliance maintains room tempera-
ture at about 5°C, preventing freezing with minimal energy
consumption.
MAINTENANCE
-
Always unplug from the mains socket before cleaning.
-
Clean the air intake and outlet grilles regularly.
-
Do not use abrasive products or solvents to clean the ap-
pliance.
TECHNICAL CHARACTERISTICS
Power supply
Absorbed power
5
See rating plate
"
Advertisement
