Balluff BTL7 Series User Manual page 37

BTL7-A/C/E/G501-M _ _ _ _ -P-S32/S115/KA _ _
Magnetostrictive Linear Position Sensor – Profile Style
4
Installation and connection (continued)
4.4 Electrical connection
Depending on the model, the electrical connection is made
using a cable or a connector.
The connection or pin assignments for the respective
version can be found in Tables 4-3 and 4-4.
Note the information on shielding and cable
routing on page 12.
4.4.1 Connector S32/cable connection KA_ _
S32 KA
Pin Wire color
1 YE yellow
GY gray
2
3 PK pink
10...0 V
4 RD red
5 GN green
0...10 V
6 BU blue
7 BN brown
8 WH white
Tab. 4-3: Connection assignment BTL7-...-S32/KA_ _
4.4.2 Connector S115
S115
Pin
-A501
1
2
3
10...0 V
2)
4
5
0...10 V
2)
6
7
8
Tab. 4-4: Connection assignment BTL7-...-S115
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
2) Factory setting, can be freely configured with the PC software.
Reference potential for supply voltage and EMC-GND.
3)
www.balluff.com
BTL7-... interface
-A501 -G501
Not used
1)
0...20 mA
0 V
output 2
10...–10 V 20...0 mA
2) 2)
La (communication line)
output 1
–10...10 V
2) 2)
GND
3)
10...30 V
Lb (communication line)
BTL7-... interface
-G501 -C501
0 V (pin 3)
0 V (pin 5)
output 2
10...–10 V 20...0 mA
2)
La (communication line)
output 1
–10...10 V 0...20 mA
2)
GND
3)
10...30 V
Lb (communication line)
-C501 -E501
output 1
4...20 mA
2) 2)
Fig. 4-9: Pin assignment of S32 connector
20...4 mA
2) 2)
Not used
1)
-E501
Fig. 4-10: Pin assignment of S115
20...4 mA
2) 2)
4...20 mA
2) 2)
(view of connector pins of BTL)
connector (view of connector
pins of BTL)
english 11