MiTAC 770 Manual

MITAC 770 ALL-IN-ONE PC CHASSIS
INTEGRATION WITH THE ASROCK H77TM
DESKTOP BOARD

1. Unfastening the Rear Cover Screws

Unfasten the two screws on the underside of the chassis to
enable the removal of the rear cover.

4. Connecting the Converter Board

Connect the supplied converter board to a single USB header the
desktop board and connect the converter cables.

7. Connecting the SATA Cables to the HDD

Before securing the HDD mounting bracket to the chassis,
connect the SATA cables.

10. Installing the VESA Mount Bracket

To install the optional VESA mount supporting bracket, remove
the 3 screws that secure the stand to the chassis and shift
downwards to free the stand from the locating pin.

2. Lifting the Rear Cover

Once the rear cover screws have been removed, slide the cover
upwards, then lift the cover away from the chassis.

5. Fitting the ODD Mounting Bracket

Fasten the ODD to the mounting bracket prior to insertion.

8. Removing and Replacing the System Fan

The system fan may need to be removed to allow SATA cable
connection. Once the SATA cables have been connected, secure
the fan by fastening all relevant screws.

11. Positioning the VESA Mount Bracket

Position the VESA mount bracket over the 4 beveled screw
mounts. Fasten all 8 screws on the bracket securely.

3. Inserting the IO Shield

When inserting the IO shield, check that it is orientated correctly.

6. Fitting the HDD Mounting Bracket

Secure the HDD to the mounting bracket prior to insertion by
fastening the 4 retention screws.

9. Fastening the Heatsink-Positioning Screw

An additional heatsink-positioning screw behind the heatsink
needs to be fastened to secure the heatsink.

12. Fastening the Additional Cover Plate

Fasten the additional cover plate to the rear of the chassis if the
VESA mount bracket is used.