Advertisement
Quick Links
PowerFlex Battery Charging System
Small and lightweight, the SKC PowerFlex
designed for optimal charging of NiCad and NiMH batt ery packs for most SKC
personal air sampling pumps. Batt eries for up to four diff erent pump models
(excluding EX and ATEX models and models with lithium-ion [Li-Ion] batt eries)
can be charged simultaneously on the fi ve-station PowerFlex.
Pump-specifi c cables are used to connect batt ery packs to the PowerFlex so that
only one charger is needed for most SKC personal sample pumps. PowerFlex fully
charges batt ery packs in 6 to 8.5 hours, and then automatically switches to a safe
pulse trickle charge. Each att ached batt ery pack runs through an independent
cycle. An LED at each port indicates batt ery charge status. Batt ery packs can be
charged att ached to or detached from the pump.
Performance Profi le*
Dimensions:
Weight:
‡
Charging time
:
Status LED:
Input voltage:
Intrinsic safety:
Approvals:
* For U.S.-produced pump models only. Not compatible with Ex or ATEX-approved models.
‡ Typical charging times vary with model, batt ery capacity, and level of discharge.
863 Valley View Road, Eighty Four, PA 15330 USA
4.4 x 5.5 x 1.4 in (11.1 x 14 x 3.5 cm)
1.1 lbs (0.5 kg)
6 to 8.5 hrs
Steady Red = Charging
Steady Green = Trickle charge
100-240 V
Not intended for use in explosive or hazardous
locations
Power supply is
is CE marked.
Operating Instructions
Tel: 724-941-9701 • www.skcinc.com
®
is an advanced charging system
for electrical safety and
Advertisement
Related Manuals for SKC PowerFlex Series
Summary of Contents for SKC PowerFlex Series
- Page 1 Small and lightweight, the SKC PowerFlex is an advanced charging system designed for optimal charging of NiCad and NiMH batt ery packs for most SKC personal air sampling pumps. Batt eries for up to four diff erent pump models (excluding EX and ATEX models and models with lithium-ion [Li-Ion] batt eries) can be charged simultaneously on the fi...
- Page 2 If any LED lights red or green upon plugging the charger into the wall outlet (no pump[s] att ached), discontinue use of the charger and return it to SKC for repair. Procedure for Charging AirChek 2000 Pumps Att ention AirChek 2000 Users: To prevent batt ery damage, follow the steps below in the order indicated.
- Page 3 Procedure for Charging Other SKC Pump Models The following instructions apply to each charging port and sample pump used. Each port operates independently. 1. Ensure the sample pump is off . 2. Select the appropriate pump-specifi c cable. 3. Insert the RJ-45 connector into a charging port on the PowerFlex. The connector should slide easily into the port.
- Page 4 † For U.S.-produced pump models only. Not compatible with Ex or ATEX-approved models. SKC Limited Warranty and Return Policy SKC products are subject to the SKC Limited Warranty and Return Policy, which provides SKC’s sole liability and the buyer’s exclusive remedy. To view the complete SKC Limited Warranty and Return Policy, go to htt p://www.skcinc.com/warranty.
Need help?
Do you have a question about the PowerFlex Series and is the answer not in the manual?
Questions and answers