SKC 223-229A Operating Instructions

Pocket Pump single charger models -
• 223-229A Single charger / mains adaptor for Pocket Pump
• 223-230A Single charger / mains adaptor with right angle output plug for Pocket
Pump
Please read these instructions before using the charger!

Specifications

Model Input
223-229A 100-240V ~ 50/60Hz
223-230A 100-240V ~ 50/60Hz

Introduction

The SKC Ltd Pocket Pump chargers provide a constant current charging output
specifically for use with the NiCd / NiMH battery charging control system built into the
Pocket Pump.
The Pocket Pump chargers may also be used as mains adaptors to enable long term
operation of the Pocket Pump.
The chargers are supplied with four inter-changeable electrical supply input plugs
suitable for use in the United Kingdom, Europe, USA / Canada and Australia / New
Zealand.

Warnings

These chargers are designed for use specifically with the SKC Pocket Pump models
and are not intended for use with any other SKC or non-SKC products.
These chargers must not be used to charge non-rechargeable batteries.
These chargers are for indoor use only, and must therefore be protected against
exposure to moisture.
Operating temperature range - 0°C to +40°C, 95% RH non-condensing.
Use of a non-SKC charger to charge SKC pump battery packs may cause damage to
the battery pack and / or pump and will void the battery pack and / or pump warranty,
also the intrinsic safety rating of the pump may be invalidated.

Charger Operation

1. Select the correct electrical supply input plug for your region and fit it to the
charger power supply unit.
2. Plug the charger power supply unit into an electrical supply socket and switch on
the electrical supply. The charger LED indicator will not be illuminated at this point.
3. Plug the charger output connector into the charging socket on the battery pack.
Pocket Pump Single Chargers
Output Battery Pack Specification
350mA NiCd/NiMH 2cell 2.4V 0.6-1.0Ah
350mA NiCd/NiMH 2cell 2.4V 0.6-1.0Ah
www.skcltd.com
Operating Instructions