Advertisement
How to maintain your vacuum cleaner
1. T he dust cup should be cleaned after each
use for optimal performance. To empty the
dust cup first remove the hand vacuum from
the main body of the vacuum cleaner. T hen
press the left and right push buttons on the
bottom of the dust cup and pull it away from
the hand vacuum to remove it.
2. Remove the filter assembly from the dust cup by using the handle on top of the filter
and pulling it out. Empty the dust cup into a receptacle and then rinse the inside of the
dust cup out with water (if desired).
3. To remove the HEPA filter, twist the handle
on the filter assembly counterclockwise
and pull it out from the housing. Rinse the
filter with warm water and leave it out until
completely dry.
5. To clean any hair on the brushroll, press the
brushroll release tab and open the brush roll
cover. Remove the brushroll and clear any
tangled hair with a blade. Finally, re-assemble the
brushroll into the floor nozzle to continue cleaning.
Release
buttons
4. After maintenance, re-assemble the
hand vacuum as shown below.
Problem solving
� Make sure vacuum cleaner is off and charging plug is unplugged.
N O T I C E
This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor
overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Check the vacuum for
a possible source of overheating such as a full dust cup or clogged filter. If these conditions are
found, fix them and wait at least 30 minutes before attempting to use the vacuum.
2) After the 30 minute period, press the power button. If the vacuum still does not work, call the
Eureka Customer Service HELPLINE at 1-800-282-2886.
Problem
• Make sure cleaner is fully powered.
Motor will not start
• See detailed "thermal cut-off" instructions above.
• Push charger securely into electrical outlet, try another
Charging indicator lights
outlet or check circuit breaker.
are not lit while charging
• Make sure charging plug is securely inserted into charging stand.
• Indicator lights stop blinking when fully charged.
• Empty dust cup and clean or change filter. See page 8 for
Not enough suction power
maintenance instructions.
• Make sure cleaner is fully powered. Charge battery.
• Remove clogs that restrict the airflow.
Not enough running
• Make sure cleaner is fully powered.
time
• Charge battery for 4 hours before using.
• Check brushroll for debris. See page 8 for maintenance instructions.
Brushroll will not turn
Discarding the vacuum and battery pack
w
Before you discard this vacuum, dispose of battery in an environmentally safe
manner. Do not discard battery with your regular household trash.
Important battery disposal information.
To find a disposal location nearest you, call 1-800-822-8837.
To preserve natural resources, please recycle or dispose of expired battery
pack properly.
This product contains a lithium-ion battery. It must be disposed
of properly. Local laws may prohibit disposal of lithium-ion batteries in ordinary
trash. Consult your local waste authority for information regarding available
recycling and/or disposal options.
:
Thermal cut-off
Solution
Advertisement
