Installation; Location - Tricity Bendix SE 211 Operating & Installation Instructions Manual

Tricity bendix electric cooker operating instruction
Table of Contents

Advertisement

This
cooker
accordance with the IEE Wiring Regulations
(Current Edition). Detailed recommendations
are contained in the following British Standards
Codes Of Practice:
B.S. 6172/ B.S. 5440, Par.2 and B.S. 6891 Current
Editions.
The appliance must be installed in accordance with
" Y " specification (EN60.335-2.6). The cooker
must not be installed higher than the worktop.
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
The appliance must not be installed in a bed-sitting
room of volume less than 20m
shower room. It is essential that the appliance is
positioned as in the enclosed figure i.e. shelves, wall
cabinets and cooker hoods must be fitted a minimum
of 690mm directly above the top of hotplate and
400mm above the hotplate when fitted in line with the
outside of the appliance. If the units are intended to
be fitted adjacent to the appliance but less than
400mm above the hotplate, then a minimum space of
100mm must be maintained between the sides of
the unit and the appliance (see fig).
If fitted next to or between two base units a
minimum space of 1mm must be left between each
unit and the sides of the appliance. The levelling
feet fitted to the appliance will achieve a nominal
height to hotplate of 900mm+10mm.
The appliance must be installed in accordance with
EN 1116-1995, regarding the depth of the superior
furniture.
The appliance must be set on a heatproof
floor. The adjustable feet must not be removed.
Levelling
The appliance is provided with adjustable small
feet placed in the back and front corners of the
base.
By adjusting the small feet it is possible to change
the height of the appliance so as to ensure a better
levelling
with
other
distribution of the liquids contained in pots and
pans.
6

INSTALLATION

must
be
installed

LOCATION

3
or in a bathroom or
surfaces
and
an
even
in
Before your appliance is connected to the mains
electricity supply, check to ensure that the voltage
and the frequency shown on the rating plate
correspond with your supply voltage.
This appliance must be earthed.
max 400
100
min 600
min 570
less than
400

Advertisement

Table of Contents
loading

Table of Contents