Table of Contents
Advertisement
6
C
o n n e C t i n G
6.1 p
ot e n t i a l
Make the potential equalisation of the SAT receiver system in accordance with
DIN EN 60728-11.
6.2 m
a i n s
Never operate the device without a protective earth connection, earth connec-
tion to the device and potential equalisation!
To maintain compliance with current EMC regulations (electromagnetic com-
patibility), it is necessary to route the power cord through the supplied ferrite
sleeve.
• Open the ferrite sleeve.
• Make a loop in the power cord and lay the loop inside the ferrite sleeve as
shown in fig. 20.
• Close the ferrite sleeve (fig. 21).
• Connect the power cord to the power socket
head-end station and plug the other end into an earthed mains socket.
t h e
h e a d
(pe)
e q ua l i sat i o n
A
Housing
Fig. 19
C o n n e C t i o n
Fig. 20
-
e n d
s tati o n
• Put the PE wire (Cu 4 - 20 mm
the hole
nal on the back side of the head-end
station and fasten the PE wire with the
B
screw
page 8, fig. 4).
• Connect the PE connection terminal to
a potential equalisation rail (supplied
by customer) using the PE wire.
- 18 -
of the PE connection termi-
A
(fig. 19) securely (see also
B
Fig. 21
(page 8, fig. 4) on the
1
) into
2
CSE 2800
Advertisement
Table of Contents
