Switch Operation Overview - Panasonic CZ-CFUNC2 Instructions Manual

4
Setting the Communication Adaptor board
The switches on the board control the adaptor numbers, turn the inter-unit control wiring connection on and off, and control

(1) Switch operation overview

Turn on the Power switch(S1) on the board.
1 Item selection
Use the and keys to find the desired item, then press the
UP DOWN
2 Changing the settings
Use the and keys to change the setting, then press the
DOWN
UP
Hold down the key for at least two seconds to reset to the default setting
HOME
lost.)
(2) Adaptor number setting procedure
1 Hold down the key for at least two seconds so the initial display shows as follows:
HOME
After 2 seconds
2 Press the key five times so the following display appears:
UP
This automatically switches to the below display after 2 more seconds. (Operation is not necessary.)
3 Press the key so the below display appears. (Only the green monitor LED is on.)
SET
4 Hold down the key for at least 1 second so the "00" part blinks, indicating that the setting can be changed. (The green and red monitor
SET
LEDs are both on.)
Use the and keys to set the adaptor number.
DOWN
UP
For example, to set number 3, press the
Press the key for at least 1 second to confirm. (Only the green monitor LED is on.)
5
SET
D 8 D7
7-segment LED
S 6 D1
HOME D2
Home key
Monitor LED
D1: red
D2: green
(no.00)
(AdP.dt)
(no.05)
(FirSt)
(1.Ano.00) (Factory setting)
key three times. The following will display:
UP
(1.Ano.03)
D6 D5 D4 D 3
S7 S8 S 9
UP DOWN SET
Set key
Down key
Up key
key to select.
SET
key to confirm.
SET
4
other settings.
(Any settings in progress will be