Interlock Switches - Bolens QS Series Service Manual

QS, QT & 1900 SERIES
TRACTORS
Page 5-6 REV. 4/83
CHASSIS {Continued)
INTERlOCK SWITCHES
INTERLOCK SWITCHES
1. One switch is on the brake
linkage. To check adjust-
ment depress brake pedal.
When brake pads contact
disc, pin (A) should just be
in slot (B) of lever (C)
Figure 5-11. If switch does
not activate adjust as
follows:
(Model 1666 S/N 0100101
thru 0199999)
Loosen hex nuts "D" Figure
5-12 and move switch sup-
port "E" either forward or
rearward until proper adjust-
ment is obtained .
. (Model 1660 & 1666 S/N
0200101 thru 0499999)
Adjust clip (F) Figure 5-14 on
brake rod till switch activates.
(Models 1666 S/N 0500101
and later & 1966)
2. A seat switch is located
· under the seat. This switch
should be activated when
back edge of seat support
(G) Figure 5-13 is depressed
5/8" (1.6 em). If not loosen .
bracket (H) and move to
correct location. The switch
can also be activated by
raising the seat and lifting
the interlock button (I) up.
I
FIGURE 5·12
FIGURE 5-13
LINKAGE