Advertisement
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in
contact with the carpet, the float will shut off the suction on the carpet washer. You will be able to hear if this has
happened as the motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full.
If the dirty water tank is not full then turn off your machine at the power switch and wait for the float to settle.
Emptying and cleaning the dirty water tank
Press the dirty water
tank release latch and
pull to remove.
Lift to remove the dirty
water tank lid and empty
the dirty water into the sink.
Rinse the dirty water tank
and lid under water (40°C
max) to remove dirt/debris.
Taking care of your machine
Lift the dirty water tank clips up and outward to release the lid.
Clean the filter screen
located at the back of
the dirty water tank.
To re-fit, tilt the dirty water tank
and line the front of the tank up
onto carpet washer. Push back
until it clicks into place.
IMPORTANT
Empty and rinse out clean
and dirty water tanks and
leave to air dry before
replacing. Do not leave
solution stored in the tanks
between uses.
Hide quick links:
Advertisement
