Advertisement
Using your machine
NOTE: The carpet washer should be in the upright position when using the hose and tools; this will de-activate
the brushbar.
Using the wash tool
Pull down the accessory hose connector cover.
Slide the upholstery tool
over the tab at the end
of the hose until it clicks
into place.
Squeeze the solution trigger to release water and solution
mix. Squeeze the trigger on the forward stroke, then
release the trigger on the backward stroke to pick up
the solution/water. For a dryer finish, follow with a slow
additional dry stroke without the trigger pressed.
Plug into the mains, press
the On/Off button to
switch on.
Push the hose end into the hose and solution connection
port until it clicks into place.
For best results do not over
saturate. For a dryer finish,
follow with a slow additional
dry stroke without the
trigger pressed.
Hide quick links:
Advertisement
