Installation; Wall Mounting - HIKVISION DS-2CE37U8T-A User Manual

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with your

power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use self-
tapping screws to secure the camera.
If the product does not function properly, contact your

dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installing the Lens
Before you start:
You should purchase a lens first.
Steps:
1. Rotate the lens clockwise onto the camera module
tightly.
2. Insert the cable attached on the lens to the auto-iris
drive interface to finish the lens installation.
3. Connect the corresponding power cord, and video
cable.
4. Power on the camera to view the image on the
monitor.
Note:
Do not pull out the cable attached on the lens when
the power is on.

2.2 Wall Mounting

Before you start:
You should purchase a wall mount first.
Steps:
1. Paste the drill template to the wall.
2. Drill screw holes in the wall according to the supplied
drill template.
Figure 2-1 Installing the Lens