Table of Contents
Advertisement
Specifying a name
Fig. 14:
Specifying a name
1. Enter a name that is easy to understand and under which the application is to be displayed
later (e.g. "Living room blind").
.
Press the tick at the bottom right.
This takes over the entry.
Note
The settings of the device can be adjusted via the Web-based user interface of
the System Access Point.
For pre-programmed devices (sensor/blind actuator unit) the default settings can
be adjusted. This allows the channel selection to be influenced.
These settings, however, can only be made in part with the fitter access (see
online Help of the System Access Point). The parameter settings remain as
described above.
Product manual 2CKA001473B9187
Commissioning
│23
Advertisement
Table of Contents
