Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Furinno 11161
Summary of Contents for Furinno 11161
- Page 1 MODEL: 11161 NO-TOOL 2 DRAWERS CHEST Rev : 01...
- Page 2 BEFORE YOU BEGIN, PLEASE READ ASSEMBLY INSTRUCTIONS CAREFULLY. FOLLOW THEM STEP BY STEP. CAUTION: 1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS. CARE SHOULD BE TAKEN IN THE UNPACKING AND ASSEMBLY OF THE PRODUCT. 2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO THE PRODUCT FINISH. 3.
- Page 3 ASSEMBLY INSTRUCTION STEP 1 INSERT DOWEL (1) TO THE PRE-DRILLED HOLES OF PANEL (B)(C)(D)(E). STEP 2 FIX LOCK SWITCH (5) INTO THE CAM LOCK OF EVERY PANELS, BEFORE ASSEMBLY THE UNIT.
- Page 4 STEP 3 ATTACH PANEL (E) TO PANEL (B). STEP 4 ATTACH PANEL (D) TO PANEL (B). TURN ON CAM LOCK AND FIX INTO THE PRE-DRILLED NUT. TURN OFF CAM LOCK WHEN THE PANEL WERE FIXED.
- Page 5 STEP 5 STEP 6 ATTACH PANEL (C) TO PANEL (D)(E). UPRIGHT THE UNIT. ATTACH PANEL (A) TO IT. REPEAT THE SAME METHOD AS STEP 4. REPEAT THE SAME METHOD AS STEP 4. STEP 7 INSERT PLASTIC PIN & NUT (3) INTO THE FOUR CORNER OF PRE-DRILLED HOLES ON PANEL (F). INSERT PLASTIC STOPPER (2) INTO THE BALANCE OF PRE-HOLES ON PANEL (F).
- Page 6 STEP 8 STEP 9 ATTACH PANEL (J) TO PANEL (H)(I). SLOT IN PANEL (K) TO PANEL (H)(I), AS SHOWN. REPEAT THE SAME METHOD AS STEP 3. ATTACH PANEL (G) TO THE ASSEMBLED SECTION. REPEAT THE SAME METHOD AS STEP 3. STEP 10 STEP 11 FIX THE HANDLE SET (4) TO THE PANEL (G).
Need help?
Do you have a question about the 11161 and is the answer not in the manual?
Questions and answers