Taylor AJ1450BL Quick Use Manual

AJ1450BL

HOW TO USE YOUR JUICE EXTRACTOR

Once you have cleaned and dried your juice extractor according to directions, place the unit on a
flat, sturdy surface (i.e., do not place on carpeting or other soft surfaces).
How to use your Juice Extractor
1. Always be sure that the appliance is properly assembled, turned on and running before
inserting food. Do not force feed the juice extractor. For most fruits and vegetables, a
slow start/stop or jabbing motion will work best. If the juicer starts to vibrate, a slightly
stronger push with the firmer item should bring it into balance.
2. When finished juicing, allow the appliance to run for a minute to allow all juice to be
extracted from the pulp.
3. It is important that you select fresh, firm and crisp produce for best juicing results.
Whenever possible, drink the juice at once. The sooner the juice is consumed, the
greater the benefit from vitamins and nutrients.
4. If storing the juice, use a glass container and add a few drops of lemon juice to better
preserve the juice. KEEP STORED JUICE REFRIGERATED.

Getting Started

1. Make sure the appliance is switched off and unplugged. Assemble the unit according to
instructions.
2. Clean and wash the fruit or vegetables to be used, and then cut into appropriate sized
pieces for feeding into the feeding funnel. Stones and pips should be removed from fruit.
3. Plug the appliance into the power outlet – remove the plug from its storage area to the
required length. Remember, the unit will not operate if the safety locks are not properly
engaged.
4. Start the juice extractor by pushing the power button and insert the prepared fruit and
vegetables into the feeding funnel and gently push down with the food plunger.
NOTE: NEVER USE YOUR FINGERS TO FEED FOOD DOWN INTO THE FUNNEL.
FOOD MUST BE FED INTO THE APPLIANCE WHILE THE MOTOR IS IN OPERATION.
Quick Use Guide –
·