PowerTec 17002 Instruction Sheet

INSTRUCTION SHEET
Workbench Casters with
Quick-Release Plates, 4 Sets
QUESTION...
1•847•780•6120
This kit contains four Workbench Quick-Release
Plates and one Powertec 17001 Workbench
Caster Kit.
NOTE: The quick-release plates can be
used with multiple sets of the Powertec
17001 Workbench Caster Kit or other
compatible brands.
PACKAGING CONTENTS
4 - Quick-Release Plates
4 - Locking Pins
8 - Bolt 1/4"-20 x 2 (50.8 mm) long
8 - Washers
8 - Nuts
1 - 17001 Workbench Caster Kit
4 - Pedal Bracket Assembly
4 - Casters
4 - Nuts
4 - Lock Washers
16 - Wood Screws
ASSEMBLE THE QUICK-RELEASE
PLATES AND WORKBENCH
CASTERS
• Make sure the stand is sitting on a flat stable
surface.
• Measure and mark 2-1/2" (65.3 mm) from
the floor to the center of the workbench leg.
(Figure 1)
• Place the caster plate onto the workbench
leg and align the bottom hole with the 2-1/2"
(65.3 mm) mark. Mark the top hole [4"
(101.6 mm)]. Remove caster plate and drill
holes into workbench leg. Repeat on each leg.
NOTE: If assembling several quick-release
plates, a template can be created.
• Mount the caster plate to workbench leg with
supplied hardware (bolt, washer, nut). Repeat
on each leg. NOTE: If the workbench leg is
larger than 1-1/2" (38.1 mm), longer bolts (not
included) will be needed.
Figure 1
1-1/2"
Washer
(38.1 mm)
Nuts
Washer
4"
(101.6 mm)
2-1/2"
(63.5 mm)
• Attach Caster to Pedal Bracket Assembly
using Nut and Lock Washer provided.
(Figure 2)
Figure 2
Caster
• With caster in the "up" position align to caster
plate and slide into place, lock in place with
locking pin. (Figure 3)
Figure 3
Caster
Locking Pin
in "up"
position
MODEL NO. 17002
Workbench
Leg
Quick-
Release
Plate
Screws
Floor
Pedal Bracket
Assembly
Nut
Lock Washer
Caster Plate