Advertisement
TO USE
PINCH HAZARD! Always use feet to
step on the caster levers.
• Step on the caster lever and the caster
assembly will extend and lift the legs off the
ground allowing the stand to be moved.
• To retract, use your foot to raise the caster
lever and the caster assembly will "snap" up,
lowering the leg.
ALTERNATE ASSEMBLY
To Assemble POWERTEC 17001
Workbench Caster Kit Without Using the
Quick-Release Plates
If using two screw assembly shown in
1.
Figure 4.
a. Mark your drill points on the workbench
leg at 2" (51 mm) and 4-3/4" (120 mm)
from the bottom of the leg.
b. Drill two pilot holes on each
workbench leg.
If using four screw assembly shown in
2.
Figure 5.
a. Mark your drill points on the
workbench leg at 2" (51 mm) and
4-3/4" (120 mm) from the bottom of
the leg.
b. Drill four pilot holes on each
workbench leg.
3.
Install Pedal Bracket Assembly to the
workbench leg with Wood Screws provided.
(Figure 4 and 5)
4.
Attach Caster to Pedal Bracket Assembly
using Nut and Lock Washer provided.
(Figure 6)
NOTE: You may need to remove the caster from
the Caster Plate to attach and secure the Pedal
Bracket Assembly to the workbench leg.
Other Installations
The workbench casters can be used on
many different tables or stands other than
workbenches. This includes router table stands,
lathe stands or anywhere in your shop where
you need mobility for a larger item. To install the
casters on a metal stand, follow the instructions
under To Assemble POWERTEC 17001
Workbench Caster Kit Without Using the
Quick-Release Plates and replace the Wood
Screws (provided) in step 2 with nuts, bolts and
washers (not provided) to properly secure the
Pedal Bracket Assembly as showing in Figure 7.
Visit us on the web at powertecproducts.com
Put these instructions and the original sales
invoice in a safe, dry place for future reference.
Southern Technologies, LLC
Waukegan, IL 60087
Figure 4
4-3/4"
2"
Figure 5
4-3/4"
2"
Figure 6
Caster
Figure 7
Nut
Metal
Stand
Workbench Leg
Pedal Bracket
Assembly
Wood Screw
Workbench Leg
Pedal Bracket
Assembly
Wood Screw
Pedal Bracket
Assembly
Nut
Lock Washer
Caster Plate
Washer
18-0709
Advertisement
