Backward - Baileigh Industrial PT-44AH-W Operator's Manual

The function can be used to check the trail and code before you start the real cutting process.
Press the red "STOP" key to stop the trial process if you want.

Backward

During the running process, if you want to go backward according to the origin trail to (maybe
the material was not cut through), you can follow the following direction:
• First, press "STOP" key to set the machine at pause status.
• In the automatic function screen, press [F3] key (Back) to make the machine go backward
along the original path.
• When the torch reaches the position you need, press "STOP" key to stop it. You may press
[F2] key to go forward if the machine just went back too much.
Note: The backward or forward function may be used repeatedly to make the
machine reach an ideal position.
• When the torch reaches the position you need, press "START" key again, if the current
cutting code is G01, G02 or G03, system will automatically perforate before performing these
procedures, and then continue the current program, if the current row is not G01, G02 or
G03, the system will directly continue the current line program.
16
16