Starting Up The Flail Head (Full Electra Version); Starting Up The Cutter Bars (Full Electra Version) - FERRI T250A Series Use And Maintenance Manual

USE AND OPERATION
6.2.5 Starting up the flail head (FULL ELECTRA version)
Make sure that the selector switch (A) is in neutral position - 0 -.
Arrange the flail head in a safe position, increase the tractor rpm and start up the rotor in the required direction of
rotation. After a few seconds the rotor will stabilise its rotation speed and be ready to work.

6.2.6 Starting up the cutter bars (FULL ELECTRA version)

Turn the selector switch (A) to the position indicated in the figure to start up the cutter bars.
This manoeuvre has to be performed with the tractor PTO running at low rpm. Then
increase the rpm gradually up to the indicated operating level.
If you turn the selector switch (A) to the direction opposite to that indicated (improper
use), the equipment will not work and the system could get seriously damaged.
CAUTION
80
0
A
A
T250A-T320A
6.7
6.8
Rev. 1.1