Starting Up - FERRI T250A Series Use And Maintenance Manual

USE AND OPERATION
6.2

Starting up

6.2.1 Preliminary checks
► Make an overall visual inspection of the machine.
► Check the tightening of all the screws.
► Check the integrity of the guards.
► Check the level of oil in the transmission unit.
► Check the cutting unit (the condition of the shaft, the wear on the flails, etc.) and make sure that all the various
parts are correctly tightened.
► Make sure that there are no oil spillages from fittings or piping.
► Check the correct operation of the electric system and the light bar (if present).
► Make sure that the speed and rotation direction of the tractor power takeoff are the same as those required by
the machine (see the sticker on the gearbox).
► If applied on a self-propelled machine, check the number of motor revolutions and the available oil flow necessary
for the hydraulic motor of the shredding flail head.
► Make sure that there are no people and/or animals present within a range of 50 metres.
► Grease all the parts of the machine.
► Move the rotor control lever (A) to the neutral position 0.
► If the machine is equipped with a support foot (1), move it to rest position as shown in the figure. This will ensure
the correct closing position for transport (included in the supply for shredding flail heads with rear hitch and for
TRM18, TR22 and CS150 equipment, regardless of the type of hitch).
0
IF THE INSTRUCTIONS ARE NOT OBSERVED, THE USER WILL BE CONSIDERED LIABLE
FOR ANY AND ALL CIVIL AND/OR CRIMINAL DAMAGE THAT MAY BE CAUSED.
DANGER
76
A
T250A-T320A
1
6.4
Rev. 1.1