Advertisement
Albeo
ABR2 LED Luminaire
®
Section 4: Pendant Mounting
A
Attach pendant mount box to ¾" NPT
conduit.Determine rotation of fixture
and lock orientation in place with provided
set screw.
Tighten
D
screw
AC power cord
AC power cord
Swing fixture closed and secure with the
slide clip. Lock slide clip in place with screw.
Line
Black
Neutral
White
Ground
Green
0-10V(+)
Purple (+)
0-10V(-)
Gray (-)
F
Single Fixture
Secure pendant mount box to fixture by fully tightening the captive screws on the sides of the pendant mount box to the fixture.
NOTE: Safety chains can be used in mounting slots at end of fixture.
1/2" bolts
B
AC power cord
Lift fixture up and hang on pendant mount
AC power cord
box using hinge piece.
E
Line
Line
Neutral
Neutral
Connect the green (ground), black (line)
Ground
Ground
0-10V(+)
0-10V(+)
and white (neutral) wires of the AC line to
0-10V(-)
0-10V(-)
the similarly colored wires of the fixture's
power cord using UL listed wire connectors.
To AC Main
Close junction box.
To 0-10V
Dimmer
Captive screws
See
Note
12"
3"
Tighten
Tighten
screw
screw
Black
Black
To AC Main
To AC Main
White
White
Green
Green
Purple (+)
Purple (+)
To 0-10V
To 0-10V
Gray (-)
Gray (-)
Dimmer
Dimmer
Dual Fixture
3
Installation Guide
C
Tighten
screw
AC power cord
Feed the AC power cord through the
conduit and into the junction box.
Line
Black
Neutral
White
Ground
Green
Line
Black
0-10V(+)
Purple (+)
Neutral
White
0-10V(-)
Gray (-)
Ground
Green
0-10V(+)
Purple (+)
0-10V(-)
Gray (-)
The 0-10V dimming option uses a 5-conductor
SOOW cable. Install cable per NEC and local
codes. For pendant mount option, cord can
be run through 1/2" NPT hole on top of the
mount box.
A 10V signal corresponds to 100% lumen
output. A 0V signal corresponds to ~10%
lumen output. Shorting the dimming wires
dims the fixture to ~10% lumen output.
Captive screws
Tighten
screw
To AC Main
To AC Main
To 0-10V
Dimmer
To 0-10V
Dimmer
See
Note
Advertisement
