Table of Contents
Advertisement
2
Connecting the Control Panel Cabling
1
No.
1
2
3
4
5
6
7
2-2
Refer to Figure 2-1 for the Control Panel rear panel connectors. Perform
Control Panel connections as described below.
2
Description
AC Power Input Connector
DC Power Input Connector
GPIO Connector Bank
TIA/EIA-422, TIA/EIA-485 Connector Bank
ETHERNET 10/100 Connector
TIA/EIA-232-F Connector
USB Connector
Figure 2-1 Control Panel Rear Panel Connectors
OGCP-9000 REMOTE CONTROL PANEL PRODUCT MANUAL
Connecting the Control Panel Cabling
3
IEC C14 female receptacle.
90-240 VAC, 47-63 Hz, auto-sensing
Dual fused; 500 mA, 250 V 5mm x 20mm
3-wire female locking connector with connections
for GND and +12 VDC.
For use with optional external DC power supply
(Cobalt PN PS-24). Provides redundant power
source when used with external DC power supply.
Also allows use where power is supplied from
distributed DC power system using optional
connector (Cobalt PN 5030-0002-000R; Conxall
PN 16282-3SG-311).
Special use. Not used for typical installation.
12 general-purpose input signals allow outside
devices to control the currently displayed
processing card, which enables automatic router
following on QC stations, or interfacing with
simple button boxes for special applications.
16 general-purpose output signals can be used to
indicate the currently selected card.
Special use. Not used for typical installation.
RJ-45 10/100 Ethernet connection to frame LAN
DB-9 TIA/EIA-232 serial control/alarm port.
Special use. Not used for typical installation.
Reserved for future use
6
4
5
Comments
OGCP-9000-OM (V2.5)
7
Advertisement
Table of Contents
