Table of Contents
Advertisement
Overview
Installing the Control Panel in Equipment Rack
OGCP-9000-OM (V2.5)
Installation and Setup
Chapter 2
This chapter contains the following information:
•
Installing the Control Panel in Equipment Rack, p. 2-1
•
Connecting the Control Panel Cabling, p. 2-2
Install the Control Panel in an equipment rack as follows:
Select a mounting location within the rack that offers proper access and
1.
meets the following requirements:
•
Standard EIA 19 in. rack mounting
•
2RU height
•
7 in. (17.8 cm) minimum available depth
Note:
The Control Panel does not require any special ventilation clearance.
Place the Control Panel in rack mounting position. Start four 10-32 x 3/4
2.
machine screws and nylon washers which secure the Control Panel to the
rack.
Evenly tighten the four Control Panel securing screws.
3.
OGCP-9000 REMOTE CONTROL PANEL PRODUCT MANUAL
Chapter 2
2-1
Advertisement
Table of Contents
