Adjusting The Blade-Brake Cable; Cleaning Under The Belt Cover; Cleaning The Wheels - Toro Recycler 22295 Operator's Manual

Adjusting the Blade-Brake
Cable
If the blade-brake cable needs to be replaced or is not
adjusted properly, adjust the blade-brake cable.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Hold the blade-control bar at 19 cm (7-5/8
inches) from the top of the handle as shown
inFigure 30.
Figure 30
1. Handle bar
2. Cable-anchor nut
4. Loosen the cable-anchor nut.
5. Pull down on the cable conduit to remove the
slack from the brake cable.
6. Tighten the cable-anchor nut.
7. Release the blade-control bar and verify there is
slack in the brake cable.
Cleaning under the Belt
Cover
Service Interval: Every 50 hours—Remove grass
clippings and debris from under the
belt cover.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover
mower housing.
g033871
3. Blade-control bar
4. 19 cm (7-5/8 inches)
(Figure 31) from the
1. Belt cover
4. Lift off the cover and brush out all the debris
around the belt area.
5. Install the belt cover.
6. Connect the wire to the spark plug.

Cleaning the Wheels

Service Interval: Every 40 hours
1. Remove the rear wheels and clean any debris
from the wheel-gear area.
1. Gears
2. After cleaning, apply a small amount of
anti-seize compound to the gears.
Note:
If you operate the machine in extreme
conditions, cleaning the wheels more frequently than
recommended will increase gear life.
Note:
To prevent damage to the bearing seals, do
not use a high-pressure water spray on the bearings.
27
Figure 31
Figure 32
g024255
g033535