Starting The Engine - Toro Recycler 22295 Operator's Manual

Starting the Engine

1. Connect the spark-plug wire to the spark plug.
2. Open the fuel valve by moving the fuel-valve lever to the right
1. Fuel-valve lever
3. Move the throttle-control lever to the C
Note:
Do not use the choke when the engine is warm.
4. Hold the blade-control bar in the Run/Shift position, about 5 cm (2 inches) below the handle (B of
Figure 15).
5. Pull the recoil-start handle lightly until you feel resistance, then pull it sharply (C of
Note:
Allow the rope to return slowly to the rope guide on the handle.
6. When the engine starts, move the throttle-control lever to the F
Figure 14
position (A of Figure
HOKE
Figure 15
16
(Figure 14).
15).
Figure
position (D of Figure
AST
g024165
15).
15).
g236733