Advertisement
2. Alignment and Adjustments
2-1 When entering the service mode;
1. Turn on the TV, and then select "STANDARD" on the picture adjustment mode.
2. Turn off the TV(STAND-BY).
3. Enter the service mode by pressing the remote control keys in the following sequence:
Info -> Menu -> Mute -> Power ON
Note : If necessary, re-do steps 1~3.
Initial display when the service mode is switched.
2-1-1 WHEN A RF SIGNAL IS RECEIVED
DEFLECTION
DEFL.
DEFL.
DEFL.
VIDEO ADJUST 1
VIDEO ADJUST 2
VIDEO ADJUST 3
VIDEO ADJUST 4
YC DELAY
VIDEO ADJUST DNIe 1
VIDEO ADJUST DNIe 2
OPTION F5 21 80
CHECKSUM 0000
RESET
T-CHMPEU-XXXX
2-1-2 SERVICE MODE CONTROL KEYS
MAIN MENU
UP / DOWN
RIGHT / LEFT
PRECAUTIONS
1. When EEPROM IC (IC902) is replaced, first connect the power cord and wait for about 4~5 seconds.
2. After replacing EEPROM IC (IC902), enter the Service mode. Next, enter the standard data or the
previous EEPROM IC data before replacement. And then check and adjust any items related to
Geometric, Picture, Option.
Samsung Electronics
480P OFFSET
1080I OFFSET
576P OFFSET
yy.mm.dd
MENU DISPLAY
Select item by moving cursor
Decrease or increase the adjustment values
Alignment and Adjustments
[Navigation Key]
2-1
Hide quick links:
Advertisement
