Advertisement
TROUBLESHOOTING
Before contacting After-Sales Service, refer to the table below. Often the malfunctions are minor and can be solved in few minutes
Malfunction
Possible cause
The plug is not inserted into the socket.
The tumble
The plug is faulty.
dryer does not
turn on.
A power failure occurred.
The door is open.
A time delay for the cycle start was set.
The tumble
The button Start/Pause was not pressed to
dryer does not
start the programme.
start
The function Key Lock was enabled (in case of
machines equipped with this option).
An appropriate maintenance was not carried
out.
The programme, the time and/or the drying
level set are not suitable for the type and the
amount of load inserted into the dryer.
The drying
times are very
The garments are too wet.
long
The dryer may be overloaded.
Room temperature.
The programme
A power failure might have occurred.
did not end.
Ligh
ashing
Water tank
The water tank is full.
Do
lter
and/or bottom
operation.
lter*
Bott
lter*
Display shows:
The machine sensors detected a failure.
"Fault FX EX"
DEMO
The cycle lasts
The dryer is in DEMO mode. (enter demo)
few minutes.
You can download the user manual by:
www.whirlpool.com.hk / www.whirlpool.com.sg
Visiting our website -
•
Alternatively, contact our After-Sales Service (See phone number in the warranty booklet). When
•
contacting our After-Sales Service, please state the codes provided on your product's identi cation plate.
Solution
Insert the plug into the socket.
Try to plug another appliance in the same socket. Do not use
connecting electrical devices to the socket, as adapters or extensions
Await the reactivation of the power supply.
Close the door.
For machines equipped with this function: await the end of the delay
Press the button Start/Pause.
Refer to the Options section and, if the Key Lock is present, disable it.
Refer to the section Care & Maintenance and perform the operations
described.
Refer to the sections Programs and Options to nd the programme
and the options most suitable for the type of load.
Carry out a washing cycle with higher spin speed to remove as much
water as possible.
Refer to the Programs section to check the max. load for each
programme.
The drying time may be longer if the room temperature falls outside
the 14–30°C range.
In case of power failure, it is necessary to press the button Start/Pause
to restart the cycle.
Emtpy the water tank. Refer to the section Care & Maintenance.
intake is free. Carrying out these operations improperly may cause
damages.
pull laundry out, to allow the heat to dissipate. Wait for about 15
minutes. Reconnect the dryer to the power supply, load the laundry
and restart the drying cycle. If the problem still occurs, contact
the After-Sales Service Centre and communicate the letters and
ashing on the display.
For instance: F3 and E2
Disable the Demo mode. The following actions must be carried out
in sequence, without breaks. Switch the machine on and then switch
it o again. Press the buttons Programme and Options until the
buzzer is heard.
Switch the machine on again. Exit from demo mode is signalled.
not enough to disable this option.
xxxx
xxxxxxxxxxxx
7
Advertisement
