Advertisement
where
grinder
Work
Act.
locate grinder in an adequate working area for its function, keep area clean, tidy and free from unrelated materials. ensure adequate
lighting.
Before each
immediately.
Warning! Always wear approved eye or face protection when operating the grinder.
Use
breathing protection in
pose
Keep hands and body clear of the work piece when operating the grinder.
maintain correct balance and footing. ensure the floor is not slippery and wear non slip shoes.
Remove ill
contain
Keep children and unauthorised persons away from the working area.
dO nOt force the grinder to achieve a task it was not designed to perform.
dO nOt operate the grinder if any parts are damaged or missing as this may cause failure or possible personal injury.
Warning! dO nOt grind, or sand any materials
dO nOt switch the grinder on whilst the wheel is in contact with the work piece.
dO nOt get the grinder wet or use in damp or wet locations or areas where there is condensation.
dO nOt use grinder where there are flammable liquids, solids or gases such as paint solvents, including waste wiping or cleaning
etc.
dO nOt touch the work piece close to the ground surface as it will be very hot. Allow to cool. the work piece may also be very sharp.
dO nOt operate the grinder when you are tired, under the influence of alcohol, drugs or intoxicating medication.
dO nOt leave the grinder operating whilst unattended.
and
and working area.
2. intrOductiOn
fitted with induction motor drive. suitable for general workshop grinding and sharpening use. two aluminous oxide grinding stones, coarse and fine.
3. SpecificatiOn
4. aSSembly
5. grinding StOneS
© Jack sealey limited
is
used
in
use
check
grinding wheel
accordance
a
hazard.
Wear
fitting
clothing. Remove ties,
and/
or
tie
containing asbestos.
Original Language Version
premises covered by
the
for
condition. If
with
COSHH regulations
ear
defenders and
gloves
watches, rings,
and
back
long
hair.
When
not
in
disconnect
from
the
Fitted
with
stone
guards,
spark
arrestors. Supplied with
Health
&
Safety
worn
or
damaged replace
if
fumes
if
other
loose
jewellery, and
BG200/99.V3|
Issue
use
switch
the
mains power supply, and clean the machine
adjustable
eye
BS
standard plug.
at
or
dust
necessary.
1
19/12/16
rags
grinder
off,
shields
and
Advertisement
