Flowserve IPS Wireless User Instructions page 16

We,
Declare in sole responsibility that the equipment:
Including all options and versions of the base model numbers to which this Declaration refers are in compliance
with the Directives and Norms specified herein.
10.1 EMC Directive 2004/108/EC
Basis for compliance:
The equipment has been assessed using the following standards and is supported by the following
technical documents:
EN 61326-1
EN 55011
EN 61000-3-2,
EN 61000-3-3,
EN 61000-4-2,
EN 61000-4-3,
EN 61000-4-4,
EN 61000-4-5,
EN 61000-4-6,
EN 61000-4-8,
EN 61000-4-11
Under these environmental and use conditions:
Technical File Reference Number: 701-5000
Installation and use of this equipment shall comply with the relevant installation and use instructions.
10.2 Low Voltage Directive 2006/95/EC
Basis for compliance:
The Single point transmitters are fully-enclosed, intrinsically-safe apparatus and are considered to meet
the requirements as set forth in the standard below without further consideration:
EN 61010-1
Page 16 of 19
10 DECLARATION OF CONFORMITY (TYPICAL)
Flowserve Corporation
10920 West Sam Houston Parkway North
Houston, Texas 77064
ELD-102-X Single Point Transmitters
SELD-103-X Smart Point Transmitters
ELD-FA-403-Receiver, AO/DO and Serial Modbus
S-EGI-NB-4/20-AC/SP, Smart RTU
ELD-FA-525-AC/SP, Intelligent Repeater
2006 Electrical equipment for measurement, control and laboratory use -
EMC requirements - Part 1: General Requirements
Industrial, scientific and medical equipment. Radio-frequency
2009
disturbance characteristics. Limits and methods of measurement
Class A, Group 1
Series, Electromagnetic compatibility (EMC).
Industrial Applications, Pollution Degree 2
2002 Safety requirements for electrical equipment for measurement, control
and laboratory use. Part 1 General requirements
REPEATER ENGLISH 701-8001-01^ 08-14
Suite 950
USA
flowserve.com