Flowserve IPS Wireless User Instructions page 14

Contact the Flowserve factory for
assistance.
Figure 11: Measuring battery level on repeater
using a voltmeter
Figure 12: Solar panel voltage regulator on solar
powered repeater
Page 14 of 19
REPEATER ENGLISH 701-8001-01^ 08-14
If communications from certain transmitting units to
the receiver are not successful, physically move
some of these transmitting units next to and with a
clear line of sight to the receiver.
If data is being read from this location, then ensure
that the repeater network is appropriately located and
functional. Confirm location of receiver enclosure is
appropriate to receive data from transmitting units
and repeater network.
8.2.2 Unit out of range of transmitting units
If communications from the transmitting units to
repeater are still not successful, physically move the
repeater next to and with a clear line of sight to the
transmitting units.
If data is being read from this location, then ensure
that the repeater network is appropriately located and
functional.
8.2.3 Transmitting units configuration incorrect
If the data received from certain transmitting units is
not accurate or missing, check those units'
configuration (refer to transmitting unit user
instructions).
8.2.4 Receiver Not Configured Correctly
Check receiver configuration to ensure it is set up to
receive data from this particular IPS Wireless system
(refer to receiver instruction and operations manual).
If none of the above solutions are successful in
getting data reception, contact the factory for
additional support.
flowserve.com