1
diskette drive tray
3
diskette drive
Installing the Diskette Drive Into the Drive Carrier
1. Align the back of the diskette drive with the back of the carrier.
2. Add the shim to the drive.
3. Gently push the drive into the carrier until it pops in securely. See Figure 3-22.
SCSI Tape Drive
This section describes how to configure and install an internal SCSI tape drive.
NOTE:
Installing a SCSI tape drive requires an optional SCSI controller card.
Removing and Installing an Internal SCSI Tape Drive
NOTICE:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product Information Guide.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the tape drive carrier from the media bay by squeezing the release tabs on either side of the carrier down and forward, sliding the carrier
gently from the bay. See Figure 3-23.
Figure 3-23. Removing and Installing the Tape Drive Carrier
2
shim
4
diskette drive release tabs (2)