Power Button; Operating Conditions - Axis Q6055-C Installation Manual

AXIS Q6055-C PTZ Dome Network Camera

Power button

Press and hold the power button to temporarily power the product when the dome cover is
removed. The power button is also used with the control button to reset the camera to factory
default settings. See page 16.
Connectors
Multiconnector
Terminal connector for connecting the supplied media converter switch, which provides the
following signals:
• DC Power
• Network (Ethernet 10/100Base-T)
• Input/Output (I/O)
Multicable connectors & I/O ports
Note
The supplied multicable is required in order to maintain the camera's NEMA/IP rating.
The multicable is connected to the camera's multiconnector, see Hardware overview on page 8.
The other end of the multicable is connected to the supplied AXIS T8607 Media Converter Switch.
See the installation guide for that product for further information, including an overview of the
I/O ports.

Operating conditions

The Axis product is intended for outdoor use.
Classification
Temperature
Humidity
1. Protected against entry of sand and dust. Clear/smoked dome cover may need to be replaced if exposed to
sandblasts.
IEC 60721-3-4 Class 4K4H, 4M4
IEC 60529 IP66
NEMA 250 Type 4x
MIL-STD 810G 500.5, 501.5, 502.5, 503.5,
505.5, 506.5, 507.5, 509.5, 510.5
-20 °C to 75 °C (-4 °F to 167 °F) with active
cooling
10–100% RH (condensing)
21
EN
1
, 514.6