Toro Workman 07347 Operator's Manual page 8

1. Screw
4. Disconnect the reservoir hose from the radiator
and plug or clamp it to retain coolant
Note:
If your machine is equipped with a black
pressurized tank, leave the hoses connected
and lift the tank off the shroud.
5. Remove the operator shield from the ROPS.
Removing the Center Console
Panel from the Workman HDX-Auto
Machines
1. Remove all knobs from console levers and from
the transmission lever by rotating the knobs
counterclockwise
Figure 3
2. Cover plate
(Figure
(Figure 4).
g023165
1. Brake lever
2. Hydraulic-lift lever knob
3).
3. Speed-range lever knob
4. Transmission lever knob
2. Remove the 4 hex-head screws that secure the
shift-indicator cover to the seat shroud
5).
1. Indicator connector
2. Shift-indicator cover
3. Hex-head screws
3. Lift the shift indicator up, disconnect the
indicator connector from the machine-harness
connector, and remove the indicator cover from
the machine
4. Remove the 6 hex-head screws that secure the
control cover to the seat shroud, and remove the
control cover
8
Figure 4
5. Transmission lever (L
position) knob
6. Hydraulic-lift lock (locked
position — left)
7. Speed-range lever (A
position)
Figure 5
4. Control cover
5. Machine-harness
connector
(Figure 5).
(Figure 5).
g024571
(Figure
g024588