3.3 (Windows only) Install CF3 Module Drivers
Windows systems require drivers for the mangOH Red's CF3 module.
To download the drivers:
1. Go to https://mangoh.io/mangoh-red-resources-software.
2. Click Download Windows Drivers to download the driver installation file.
3. Run the downloaded .exe file and follow the prompts to install the drivers.
3.4 (Linux only) Remove modemmanager
Make sure the modemmanager package is removed from your Linux system—this package causes problems with
the mangOH Red if it is not removed:
$ sudo apt-get remove -y modemmanager
3.5 (Virtual Machine Users) Install the mangOH Virtual
Machine
If you prefer to develop on a virtual machine on your Mac OS X, Windows or Linux system:
•
Follow the instructions at
machine for mangOH development.
The mangOH VM is pre-installed with Sierra Wireless' Leaf Workspace Manager.
Note: If the prompt "[sudo] password for mangoh" appears while in the VM, type "mangoh" and press Enter. (The VM's
account name and password are both "mangoh".)
3.6 Prepare Your mangOH Red
Your mangOH Red comes partially assembled with the CF3 module and cover pre-installed. All you need to do is
connect a few components and a power source:
1. Make sure the dipswitches are set correctly:
a. Remove the protective film from the dip switch block.
Remove this film
Rev 1 2020-03-01
mangoh.io/setting-up-vm
9
3.3: (Windows only) Install CF3 Module Drivers
to download and install VirtualBox, and load a virtual
41113734