urban drivestyle UNI MK Classic User Manual page 15

STEP 3: Slide the wheel into the fork. Ensure 2 washers remain in the disk side and one on the other side towards the inside of the fork dropout.
If necessary slightly force the fork open to slide the wheel in. Be careful with the caliper when the disk is slide inside.
STEP 4: Put the retaining washer and the nut on each side of the front wheel axle.
Ensure the pin of the retaining washer is inside the slot of the fork dropout.
Tighten the nut.
STEP 5: Lock again the brake caliper. For this operation, pull the brake lever until the caliper is pressing the disk (braking),
screw tighten both M6 allen screws in the caliper mount while pulling the brake lever. When tightened you can release the brake lever. Check
for right operation of the brake system.
15