Advertisement
2. Mounting
6
3
2
Mounting of operator display in IP 55
cabinet
• Fit the cable gland in the bottom of the
IP 55 cabinet.
• Insert the cable through the cable gland and
tighten the nut.
• Connect the wires to the five terminals of
the plug on the back of the operator display.
• Insert the plug into the operator display.
• Assemble the operator display and the
IP 55 cabinet with the four TORX screws,
type M5 x 40 PH-FZB.
Note: To meet the enclosure class IP 55, the
cable gland must be fitted correctly and the
screws must be tightened until the gasket is
deformed.
• The operator display can now be fitted in
three different angles, depending on the
selected steel frame.
Operated from the front – vertical
• Fasten the stainless steel frame to the wall
or a similar solid surface.
• Fasten the frame with three screws (pos. 3).
The three holes on the back of the frame lie
on a circle with a diameter of 170 mm.
Note: The frame can be adjusted as the three
holes are oval.
• Assemble the operator display and the
stainless steel frame with the four hexagon
socket head screws, type M4 x 6 US-A4
(pos. 2).
Advertisement
