und die Rechtwinkligkeit zum Höhenruder.
Motor
Motor
24. Locate the motor, gear motor mount, drive shaft, bearing and e clip, 3x5mm screws and M3
washers.
Suchen Sie Teile für die Antriebseinheit zusammen. Getriebe und Motorhalter, Antriebswelle mit
aufgepresstem Zahnrad, Kugellager und E-Clip, 3x5 Schrauben, Unterlegscheiben und Muttern.
25. Press the bearings all the way in then insert the drive shaft. Snap on the e clip and make sure
the e clip is well positioned and drive shaft will not come off.
Drücken Sie die Kugellager in die Kunststoffmotorträger, führen Sie die Antriebswelle von vorne
hindurch und sichern Sie die Welle an der hinteren Seite mit dem E-Clip. Das Zahnrad muss ,
wie auf dem Bild gezeigt, vorne sitzen.