Carton Contents - Bowers & Wilkins SA250 Mk2 Custom Installation

1. Introduction
Thank you for choosing Bowers & Wilkins.
The SA250 Mk2 is designed to power and apply the
correct equalisation to the ISW-3 and ISW-4 custom
install subwoofers. It is not suitable for driving any other
loudspeakers.
Please read this manual fully before unpacking and installing
the product. It will help you to optimise its performance.
In addition, please read and observe the important safety
instructions on the accompanying leaflet. Keep both
documents in a safe place for future reference.
Installation instructions for the subwoofers themselves are
provided with those products.
B&W maintains a network of dedicated distributors in over
60 countries who will be able to help you should you have
any problems your dealer cannot resolve.
Environmental Information
This product complies with international directives, including
but not limited to:
i The Restriction of Hazardous Substances (RoHS) in
electrical and electronic equipment,
ii The Registration, Evaluation, Authorisation and
restriction of CHemicals (REACH)
iii The disposal of Waste Electrical and Electronic
Equipment (WEEE).
Consult your local waste disposal authority for guidance on
how properly to recycle or dispose of this product.
4

2. Carton contents

In addition to the amplifier itself, check in the carton for:
1 x Power cable
1 x 4-pole Neutrik® Speakon® plug
2 x Rack-mount brackets
4 x Long Phillips screws and washers
6 x Short Phillips screws and washers
4 x Rubber hole plugs
2 x Handles