Starting Warm Engine - Echo CS-310 Operator's Manual

CS-310
5. Push purge pump (B) 3 to 4 times or until fuel is visible in purge
pump.
6. Pull choke control knob all the way OUT (CLOSED [
position).
• After choke control knob is pulled and then knob is returned to
original position, throttle remains slightly open (fast idle latch
condition).
• The chain will attempt to move when engine is started with fast idle throttle latch engaged.
• Do not start engine before chain brake is locked.
7. Securely hold the chain saw and pull starter handle several times
until first starting sound.
8. Push choke control knob all the way IN (OPEN [ ]choke
position).
9. Pull starter handle to start the engine.
Note: Do not pull starter rope out to the maximum possible position.
Note: Do not allow recoil handle to snap back against the casing.
Note: If engine does not start after 5 pulls, repeat instructions.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
• After starting the engine, immediately squeeze and then release throttle trigger to release fast idle
throttle latch, otherwise severe brake damage may occur.
• Never use fast idle throttle latch for cutting.
• Use the fast idle throttle latch only in starting.

Starting Warm Engine

Make sure the bar and chain are free from any obstruction when starting the chain saw.
X7503277900
©3/2020 ECHO Inc.
] choke
OPERATION
B