Preparation For Use - Echo CS-310 Operator's Manual

DESCRIPTION

Preparation For Use

Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury
may result.
Instructions to install optional Kick Guard
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
1. Install bolt (A) in rear hole (B) of Kick Guard
hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in tip guard must engage recess (E)
in guide bar.
3. Securely tighten nut (F) and bolt (A).
Guide Bar and Saw Chain Installation/Removal
1. Release the cylinder cover latches, and remove the cylinder cover.
2. Remove spark plug lead.
3. Remove sprocket guard nuts (A) and remove sprocket guard
(B).
4. Remove guide bar and saw chain if necessary.
Note: See "Maintenance and Care" section for guide bar/saw chain
maintenance procedures.
5. Unlock the chain brake, and mount guide bar on studs (C) and
slide toward sprocket (E) to make saw chain installation easier.
Install chain with cutters on top of guide bar facing forward.
16
TM
TM and through front
A
D
E
F
B
E
F
B
X7503277900
©3/2020 ECHO Inc.
CS-310
B
C
A
C
D
A