Advertisement
Quick Links
Advertisement
Related Manuals for wingtra One
Summary of Contents for wingtra One
- Page 1 Wingtra Support Changing from Rededge to RGB Camera wingtra.com...
-
Page 2: Required Equipment
R E Q U I R E D E Q U I P M E N T Required Equipment WingtraOne Torx screw driver RGB camera and mount Closed Topcover Micro USB storage adapter with SD card (only for QX1 camera) PPK module (if applicable) Three M3x12 torx screws Caution... - Page 3 ST E P BY ST E P P R O C E D U R E Step by step procedure Make sure WingtraOne is not powered 6 Lift out the camera mount assembly Insert the RGB camera mount with camera 2 Lay down WingtraOne on a flat surface 3 Open the topcover 8 Tighten the screws in all four corners using the torx...
- Page 4 ST E P BY ST E P P R O C E D U R E b Carefully insert the white PPK module. Pay attention 11 Make sure to have a SD Card inside the camera or to to not pull out the connected cable. insert the micro USB SD card reader to the micro USB port of WingtraOne (for QX1 camera) c Fixate the PPK module using the three torx screws...
- Page 5 This can take some time. Wait at least more than a minute for WingtraOne to establish the connection. e Confirm by clicking “Yes” Repower WingtraOne to safe the new camera For assistance or further information visit support.wingtra.com or contact support@wingtra.com...
- Page 6 For a quote, a live demonstration or more information For assistance or further information visit support. on the Wingtra products please contact us via wingtra.com or contact support@wingtra.com www.wingtra.com/where-to-buy or hello@wingtra.com Wingtra AG Giesshübelstrasse 40 support@wingtra.com 8045 Zürich, Switzerland wingtra.com...
Need help?
Do you have a question about the One and is the answer not in the manual?
Questions and answers