Table of Contents
Advertisement
Main Unit Controls
Main Unit Controls
Power On/Off
Reset
Volume Down
Volume Up
Source : AirPlay
Direct mode
Source Select :
Dock - USB
Source Select :
Anologue Jack
Wi-fi Connection
Settings Mode
LED#1 : Wi-fi Status and Remote Feedback.
When you switch on the unit, the LED#1 will slowly flash blue looking for the Wi-Fi network. It will continue to flash Blue until the network is set.
When the unit is connected to your network, the LED#1 will turn to solid Blue.
When you press any control on the IR remote control, the LED#1 will flash red/blue to indicate that the connection is done.
LED#2 : Input Indicator.
Press
for Airplay input - The LED#2 turns blue.
Press
for Dock input - The LED#2 will turn red.
Press again
for USB input - The LED#2 will turn green.
Press
for Jack Aux Analogue input - The LED#2 will turn purple.
• Single press will power On or power Off the unit. When the unit is Off, the two LEDs willnot be illuminated.
When the Unit in On, the two LEDs will be illuminated. LED color will depend on the input and settings.
• Press and hold for 5 seconds to reset the unit's sound settings (volume and subwoofer level to zero).
• Single press will decrease the volume one step - The LED#1 will flash red once.
• Press and hold will decrease volume gradually - The LED#1 will flash red continuously.
• Single press will increase the volume one step - The LED#1 will flash red once.
• Press and hold will increase the volume gradually - The LED#1 will flash red continuously.
• Single press will enable Airplay mode - The LED#2 will turn Blue.
• Press and hold for 5 seconds will enable the Wi-Fi direct mode, the unit will turn into a router and you'll be able to
stream from your Airplay device directly to the unit without any external network.
• First single press will enable dock input - The LED#2 will turn Red
• Second single press will enable USB input - The LED#2 will turn Green
• Single press will enable the jack input - The The LED#2 will turn Purple.
• Single press will copy the Wi-Fi settings of your wired device to the unit. The unit will be available on the same
network as your device.
• Press and hold for 5 seconds will turn the unit to Wi-Fi settings mode - The LED#1 will flash Blue/Purple. See section
«How To : Connect to the network for Airplay #2» for more details.
Back of the unit
Advertisement
Table of Contents
