Placement and Installation : The location of your iT1air in the room is crucial for sound quality and bass level. The unit is equipped with two side subwoofers and is able to reproduce very low frequencies. Some guidelines should be followed to get the best possible result.
Main Unit Controls Back of the unit Main Unit Controls • Single press will power On or power Off the unit. When the unit is Off, the two LEDs willnot be illuminated. Power On/Off When the Unit in On, the two LEDs will be illuminated. LED color will depend on the input and settings. Reset •...
2, iPad, iPad mini, iPod touch (1st through 5th generation), iPod classic, and iPod nano (1st through 7th generation). AC Power Socket. Connect your iT1air to the power supply. Use the included power cord. The unit is compatible with 100~120V / 220~240V AC, 50~60Hz. You don’t need to move any switch, the selection is automatic.
Page 5
IR Remote Control Behavior. • A single push will power On or power Off the iT1air. When the unit is Off, the two LEDs will be Off. Power On/Off When the Unit in On, the two LEDs are on. LEDs colors depend on the input and wifi settings.
Page 6
4. Push once. The unit will display a message on your iDevice asking if you want to share your Wi-Fi settings with the iT1air. Accept. The iT1air is now available in the Wi-Fi network. The LED#1 will illuminate solid Blue. You can disconnect your device now.
Press and hold for 5 seconds the Airplay control (on the Unit or on the Remote) will enable the Wifi Direct mode. The name of the network (SSID) is « MTX iT1air» . The unit will turn into a router and you’ll be able to stream from your Press and hold for 5 seconds.